Danaher Motion
04/06
Using P7000Tools
This screen is where you will enter custom motor parameters. The steps to define a custom
motor are:
Properties:
NOTE
The Properties box must be populated with values
from a motor data sheet. All other values are
calculated by the GUI software.
Motor Name
Enter an appropriate motor name.
Motor Current
:
Continuous current ratio of the motor (A
RMS
).
A
PEAK
is automatically calculated by the GUI
software.
Tooth Count
Total number of magnetic poles on the motor stator.
The default is 50.
Peak Torque
Peak output torque of motor in N-m.
Rotor Inertia
Inertia of motor rotor in kg cm
2
.
NOTE
Frequency equations illustrated later use rotor
inertia in units of kg m
2
4.4.4 MECHANICAL
M-SD-7AC-01 Rev
D
27