Using P7000Tools
04/06
Danaher Motion
Operating Current
A
RMS
Continuous current rating for the selected motor.
A
PEAK
Peak current rating for the selected motor. (Calculated by GUI based
on continuous current rating.)
Tooth Count
Number of magnetic poles on the stator.
Peak Torque
Peak torque capability of the motor.
Rotor Inertia
Rotor inertia of the motor.
Probe Stepper
Motor
When a new motor is selected, you are prompted to allow a PROBE. This is
similar to what an inductance meter does to measure inductance. The
P7000 uses a more powerful test signal, which makes an audible tone in the
motor. The probe action takes 10 to 20 seconds, during which time, the
drive is gathering information needed to operate state observers. It may be
desirable to manually start a probe using the PROBE STEPPER MOTOR
button. This would be done if a motor were replaced by a unit of the same
type.
4.4.3.1.
Motor File Editor
Motor List
List box that contains all of the motor file configurations available in the
database on this PC. Select a motor from this list to edit or select NEW to
configure a new motor.
26 Rev
D
M-SD-7AC-01