GENERAL INSTRUCTIONS FOR SWINGING ANCHOR SYSTEMS
17
Dana Incorporated
IMM-0005EN Posiplan (MT-5215-0806)
a -
3 - Machine shaft Seat
b -
1 - calibrated journal pin
ASSEMBLY WITH COUPLING
•
Glean and degrease the internal surface of the gear unit and machine shafts.
•
Lubricate the coupling housing (Fig.4 pto. A).
•
If the coupling is new there is no need to disassemble it and grease it.
•
When servicing the coupling, disassemble it and grease the zones marked “C” (see fig. 4).
•
Fit the coupling in its seat on the gear unit shaft without tightening the bolts, positioning it as shown in “a” (see Fig. 4).
•
If the gear unit works in the vertical plane with the relative output shaft facing downwards, make sure the joint cannot slip
off and fall; whatever the case, never tighten the bolts before fitting the shaft in its seat.
Fig. 3
Fig. 4
5
2
4
A
B
ØDC
ØDS
HS
a
S
d
A
