Dalsa Xtium2-CXP PX8 Quad, User Manual, Page: 55 / 130

Xtium2-CXP PX8 User's Manual CamExpert Quick Start
•
53
Basic Timing Category
The Basic Timing category groups parameters such as camera type, the active image size, and
other settings related to basic timing.
Parameter Descriptions
The following table describes the CamExpert Basic Timing category of Sapera LT parameters.
Acquisition server notes, if applicable, indicate if parameter availablility or supported values are
dependent on the selected frame grabber acquisition server and acquisition device.
Display Name
Parameter Description Notes
Camera Type CORACQ_PRM_SCAN Video source image type. Possible
values are area scan or line scan.
Not shown for Bayer
servers (areascan only).
Color Type CORACQ_PRM_VIDEO Sets the color format of the input
source.
Not shown for RGB
servers.
Monochrome servers
support:
Monochrome
Bayer mosaic
Pixel Depth CORACQ_PRM_PIXEL_DEPTH Pixel depth (bits per pixel) of the input
source.
Not shown for RGB
servers.
Monochrome servers
support:
8, 10, 12, 14 or 16 bit
Data Lanes CORACQ_PRM_DATA_LANES Number of data lanes output by the
camera.
Horizontal Active (in
Pixels)
CORACQ_PRM_HACTIVE Sets the horizontal camera resolution
in pixels. This corresponds to the
visible part of the image from the
camera.
Valid range is:
min = 32 pixel
max = 65536 pixel
step = 32 pixel
Note: minimum is per lane
Vertical Active (in Lines) CORACQ_PRM_VACTIVE Sets the vertical camera resolution in
lines per frame. This corresponds to
the visible part of the image from the
camera. Valid range is 1-16777215.
Not shown for linescan
cameras.
Bit Transfer Rate CORACQ_PRM_BIT_TRANSFER_RATE Sets the transfer rate between the
camera and the frame grabber.
PoCXP CORACQ_PRM_POCXP_ENABLE Enables 24V output on the lanes if
PoCXP is supported by the camera’s
connected lane.
PoCXP Status CORACQ_PRM_SIGNAL_STATUS Shows the current status of the
PoCXP. If at least one lane is powering
camera with PoCXP, it will indicate
‘Active’.
This is a read-only status.