Xtium2-CXP PX8 User's Manual
Installing Xtium2-CXP PX8
•
17
Sapera LT Library & Xtium2-CXP PX8 Driver Installation
Sapera LT SDK (full version), the image acquisition and control SDK for Teledyne DALSA
cameras and frame grabbers is available for download from the Teledyne DALSA website:
http://teledynedalsa.com/imaging/support/downloads/sdks/
Run-time versions are also available for download at this location.
The Sapera LT SDK installation includes compiled demo and example programs, along with
project source code, in both C++ and .NET languages, for most Microsoft Visual Studio
development platforms. The Sapera LT ++ and Sapera LT .NET demo source code are
found in the Sapera\Demos directory.
Teledyne DALSA Device Drivers
All Teledyne DALSA device drivers are available for download from the Teledyne DALSA website:
https://www.teledynedalsa.com/imaging/support/downloads/drivers/
Installation Procedure
•
Sapera LT is installed before Teledyne DALSA board drivers.
•
Download the Sapera LT SDK from the Teledyne DALSA website and run the executable file; the
installation menu is presented.
•
The installation program may prompt to reboot the computer. It is not necessary to reboot the
computer between the installation of Sapera LT and the board driver.
•
Download the Xtium2-CXP PX8 device driver from the Teledyne DALSA website and run the
executable file; the installation menu is presented.
•
During the late stages of the installation, the Xtium2-CXP PX8 firmware loader application
starts. This is described in detail in the following section.
•
Reboot once all the software and board drivers are installed.
If Windows displays any unexpected message concerning the board, power off the system
and verify the Xtium2-CXP PX8 is installed in the slot properly. You should also note the
board’s status LED color and compare it to the defined LED states as described in
Refer to Sapera LT User’s Manual for additional details about Sapera LT.