Dalsa Genie Nano-CXP Series, User Manual

Page: 51 / 107

Genie Nano-CXP Series™ Operational Reference
•
49
Advanced Processing Control Category
The Genie Nano-CXP Advanced Processing controls, as shown by CamExpert groups parameters
used to configure pixel replacement, flat field correction (column based), and lens shading
correction controls on monochrome cameras. Parameters in gray are read only, either always or
due to another parameter being disabled. Parameters in black are user set in CamExpert or
programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.
It is recommended that the user performs a Flat Field Calibration and save the results to the User
Set if the camera is normally operated at a high temperature than the 55˚C that the factory
calibration was done. This eliminates the Fixed Pattern Noise (FPN) that increases at higher
temperatures.