Dalsa Genie Nano-5G Series, User Manual

Page: 37 / 204

Nano-5G Series GigE Vision Camera Connecting the Genie Nano-5G Camera • 35
LED Indicators
The Genie Nano-5G has one multicolor LED to provide a simple visible indication of camera state,
as described below. The Nano-5G Ethernet connector does not have indicator LEDs; the user
should use the LED status on the Ethernet switch or computer NIC to observe networking status.
Camera Status LED Indicator
The camera is equipped with one LED to display its operational status. When more than one
condition is active, the LED color indicates the condition with the highest priority (such as
– an
acquisition in progress has more priority than a valid IP address assignment).
Once the Genie Nano-5G connects to a network and an IP address is assigned, the Status LED will
turn to steady blue. Only at this time will it be possible by the GigE Server or any application to
communicate with the camera. The following table summarizes the LED states and corresponding
camera status.
LED State Definition
LED is off
No power to the camera
Steady Red
Initial state on power up before flashing.
Remains as steady Red only if there is a fatal error.
Camera is not initialized **
Flashing Red Initialization sequence in progress
**
Wait less than a minute for the Nano-5G to reboot itself.
Steady Red +
Flashing Blue
Fatal Error. If the Genie Nano-5G does not reboot itself contact Technical
Support.
Slow Flashing Blue Ethernet cable disconnected. The camera continuously attempts to assign
itself an IP address.
Fast Flashing Blue File Access Feature is transferring data such as a firmware update, etc.
Steady Blue IP address assigned;
no application connected to the camera
Steady Green Application connected
Flashing Green Acquisition in progress. Flashing occurs on frame acquisition but does not
exceed a rate of 100ms for faster frame rates.
Note : Even if the Nano-5G has obtained an IP address, it might be on a different subnet than the NIC it is
attached to. Therefore, if the Nano-5G LED is blue but an application cannot see it, this indicates a network
configuration problem. Review troubleshooting suggestions in the Network Imaging manual.
LED States on Power Up
The following LED sequence occurs when the Genie Nano-5G is powered up connected to a
network.
Flashing Red
initialization
Flashing Blue
waiting for IP
Blue
IP assigned
Green
application
connected
Red
power connected