MicroStreamer-PoE
www.dallmeier.com
46
Note the explanations below.
Adjust all necessary settings.
Confirm with
OK
.
Check the image in the live video frame in the bottom left of the configuration user inter-
face (if active).
If necessary, readjust the settings and confirm with
OK
again.
Finally close the dialogue with
Cancel
.
You can restore the factory sensor settings at any time by clicking “Default”.
3dVNC Noise filter
The digital 3dVNC Noise filter provides the reduction of image noise.
In contrast to analogue filters, the image noise is not reduced by smoothing the image. The
temporal 3D filter compares individual pixels in sequential images and identifies typical
fluctuations in the colour and brightness values. Only when the fluctuation exceeds a set
limit, the pixel will be filtered out.
Note that setting the filter for fast-moving objects may result in motion blur. This drawback
is due to technical reasons and cannot be completely avoided.
10.3
Encoder settings
The audio and video encoding is configured in the
Encoder settings
dialogue.
This dialogue may be locked by external devices/applications.
10.3.1
Encoder 1
Open the
Encoder settings
dialogue via
Video
>
Encoder settings ...
.
The
Encoder 1
tab is displayed.
Fig. 10-3
Note the explanations below.
Select the encoding standard from the drop-down list
Encoder mode
.
Select the frame rate from the drop-down list
Frames/Second
.
Select the
Resolution
(width × height in pixels).
Select the
Deinterlacing
mode.
Select the
Bitrate
.
