17
Dallmeier electronic GmbH & Co.KG
a) max. 5mm
6
Connection and installation
6.1
Note ambient conditions at mounting site
The camera was designed for indoor use. When used outdoors,
the camera must be mounted in an appropriate weatherproof
housing.
Do not install/operate the camera in places:
"
with steam or oil vapors (e.g. kitchen)
"
near sources of strong radiation, i.e. X-rays, radio transmitters
or magnetic fields
"
with corrosive surroundings (e.g. gases or salt water)
"
with large scale dust and dirt.
"
with an ambient temperature above 50 °C.
6.2
Attaching the lens
IMPORTANT
Possible damage to the sensor caused by too long
lens thread and protruding parts.
Ensure that the length (a) of the lens thread (see
following figure) plus any protruding parts does
not exceed 5 mm.
Check whether it is a CS-mount lens.
If a C-mount lens is used, an appropriate
adapter ring is to be used.
NOTE
The camera is pre-configured for use with DC-
controlled lenses. For lenses with manual iris
setting, the configuration is to be changed
according to section 8.1.
Summary of Contents for DF2000A
Page 1: ...Installation and Configuration Color Video Camera DF2000A Rev 3 1 0 060801 English ...
Page 12: ...12 Color Video Camera DF2000A Dallmeier electronic GmbH Co KG ...
Page 20: ...20 Color Video Camera DF2000A Dallmeier electronic GmbH Co KG ...
Page 24: ...24 Color Video Camera DF2000A Dallmeier electronic GmbH Co KG ...
