ROLLOMAXIMUM XL
Page 25
Lubrication points
Num-
ber of
nip-
ples
Lubrica-
tion in-
tervals,
hours
Balloon
Flange bearing rear cross-kill roller
16
50
A
Spindles rear levelling board / front crackerboard
26
25
B
Cylinders harrow hoist
4
8
C
Parallel-arm harrow hoist
64
8
D
Connecting arm harrow hoist
8
8
E
Bearing front cross-kill roller (side)
8
50
F
Chassis front bearing suspension (side)
16
8
G
Bearing front cross-kill roller (centre)
2
50
H
Chassis front bearing suspension (centre)
2
8
I
Cylinder front cross-kill suspension (centre)
2
8
J
Extend/retract cylinders (red)
8
25
K
Tilt cylinders (white)
4
25
L
Cylinders and chassis wheel frame
8
8
M
Chassis centre frame
6
8
N
Chassis and cylinder track loosener
4
25
O
Lubricate all lubrication points at least once annually.
Adjustment
Wheels
Lubricate and adjust wheel bearings at least once annually. Check tyre pressures
at least once annually (see recommended pressure on tyre).
Adjustment and lubrication of wheel bearings
1.
Remove hub caps.
2.
Remove split pin.
3.
Tighten castle nut 1/6th of a turn until hole aligns with axle. Turn wheel, check
for resistance. A little play should be detected in the hub housing when rocking
wheel from side to side. If play is excessive, repeat process.
4.
Replace split pin
5.
Fill hub cap ¾ full with grease. Replace.
Hydraulics
Check all hydraulic hoses for wear or cracks. Check all hoses for crimping.
Lubricate exposed rams with oil or pressure-resistant grease to avoid rust
forming when storing for long periods. Remember to remove before use.
