DALBO MEGAROLL 2130, Manual, Page: 27 / 38

MEGAROLL
25
Adjustments
Adjustment of the rings
During adjustment of the rings, gloves and hearing protection must be used
After the first season, the rings will have worked themselves slightly loose on the shaft. By moving
the stop rings on the shaft, the rings can be clamped together to remove any slack in the rings.
Adjustment of the three middle sections is performed differently than the remaining roller sections, as these
are suspended differently.
Adjustment of the rings is best completed with the MEGAROLL folded.
Adjustment of rings on the three outermost sections.
Fig. 25
1. Loosen the bolts (A) and push the rings together.
2. Tighten and loosen the bolts in the stop rings in
the same place on the axle a few times, so that
the bolts are better attached to the axle.
Adjustment of rings on the three middle sections
There are two different ways to shim the rings on the three innermost sections.
Fig. 26
1. Loosen the bolts (A) and remove the end disc.
2. Shim up the middle rings in one of the 2 following
ways
a. Loosen the set screw in the bearing (B), so
that the bearing is loose on the axle, and
loosen the bolts (C) for the suspension. Press
all the rings together and retighten the
bearing and bolts.
b. It is possible to purchase two small split
washers to shim the rings up between the
bearings, without removing the bearing. Press
these directly around the axle after the rings
have been pressed together.
3. At the end disc, the necessary washers must be
added after the rings have been pressed
together and refit the end disc again. Secure the
screws with Loctite.
C
B
A
A