DALBO MAXIDISC, Manual, Page: 25 / 38

MAXIDISC
Side 25
 Tighten all nuts, bolts, hydraulic fittings or any other fastened assemblies after the
first workday. Inspect all pins and bolts for wear or damage and make sure that all
are securely in place to avoid any possible damage or breakdown of the machine.
Before servicing the machine, always lower the implement, engage the tractor
brakes, stop the engine and remove the ignition key to avoid unintentional opera-
tion and personal injury.

Lubricate all lubrication points at least once a year.
Hydraulic System
Inspect all hydraulic hoses for chafing or leaks. Check hoses for pinching.
 To avoid rust, any projecting or exposed piston rods should be coated with oil or
grease if the MAXIDISC is to be parked for a long period of time. Remember to re-
move the oil or grease prior to operation.
Disc Hubs
Disc hubs
Tighten the disc hubs once a year or as needed.
Fig. 17
1. Screw off the cap (A).
2. Remove the split cotter pin
from the nut.
3. Tighten the nut ¼ turn or until
there is no play in the hub.
A