8
Faults
Seite | 49
7
Decommissioning the appliance
Observe the sequence of the work steps:
54.
Pull out the mains plug or switch off the fuse for the plug socket.
55.
Turn off the water tap.
56.
Loosen the inlet and outlet hose.
57.
Loosen fixing screws from the worktop, if present.
58.
Remove the base board, if present.
59.
Pull out the appliance, carefully pulling out the hoses at the same time.
Allow remaining water to drain from the hose
If the sink is 1000 mm or more from the floor, the remaining water cannot run out
directly into the sink.
In this case, collect the remaining water from the hose in a suitable vessel outside the
sink.
Transport
✓
Empty the appliance and secure loose parts.
✓
Transport the appliance only upright (so that no remaining water can run into the
machine controller and cause programme errors).
8
Faults
Before you contact after-sales service
FAULT
POSSIBLE CAUSE
REMEDY
Appliance is not
working.
Fuse blown or fused circuit-
breaker tripped.
Check fuses.
Plug is not plugged in to the
plug socket.
Plug the mains plug into the
plug socket.
Low water pressure
Check whether the water
supply hose is correctly
connected and the tap is
properly turned on.
Appliance door does not
close properly.
Close the appliance door.
Dishes are not dry or
not properly dry
No rinsing agent used or
dosage set too low
3.
Fill with rinsing agent
4.
Regulate rinsing agent
quantity
Dishwasher detergent used
has poor drying capacity
Use rinsing agent or combined
detergent with higher drying
capacity
Selected programme has no
"Dry" function
Select programme with "Dry"
The "Extra dry" function was Activate the "Extra dry"
