Daktronics Tuff Sport TN-2562, Display Manual

Page: 19 / 62

Electrical Installation 13
Wireless Connection to Scoreboard
For multi-court scoreboards with TNMCs and a wireless signal to the scoreboard(s), refer to
the instructions below and Drawing B-1077063 in Appendix A .
1. Plug in the wireless base station (part # 0A-1110-0037) within 12' (3.6 m) of the
DakTennis computer. Ensure the wireless base station is set to
Function “5” .
2. Connect the 9-pin serial cable (part # W-1267) between the RS232 jack of the wireless
base station and an available COM port on the DakTennis computer.
Note: If the DakTennis computer only has only one or no COM port, it will be
necessary to use USB-to-Serial converters (not provided by Daktronics).
3. Connect the 9-pin to 25-pin serial cable (part # 0A-1374-0106) between the DakTennis
computer and the J6 I/O PORT jack of a radio-equipped All Sport 5000 console.
4. Ensure the All Sport console and the primary scoreboard as well as any auxiliary
single-court scoreboards are set to the same radio Broadcast and Channel numbers.
The console must also be set to
Code 5900 .
4.5 All Sport CG Setup
An All Sport CG allows live game information to be overlaid onto a video signal. This setup
requires an All Sport CG unit and video camera for each court, a signal distribution amplifier,
and associated wiring. Refer to
Drawing B-231298 (wired) or Drawing B-1077063 (radio) for
more information about typical setups.