Daktronics OMNISPORT 2000, Operation Manual

Page: 92 / 182

Diving Mode Operation, Menus, & Settings
82
Digit Number
This menu shows the digit designation.
SHOWING DIGIT #
ENTER TO EXIT
From Main Menu – [5]>[2]>[3]
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. Press [ENTER] to exit the menu.
Judge Consoles
This menu tests whether or not the judge consoles are
connected to and communicating with the OmniSport 2000
timing console. The right LCD alternates between the below messages:
JUDGE CONSOLE
TESTING MODE
From Main Menu – [5]>[3]
N=NEAR F=FAR
?= NOT CONNECTED
The left and middle LCDs indicate where a judge console is connected in the rear of the
OmniSport 2000 console:
1 2 3 4 5 6 7 8 9 10
N ? ? ? ?
2
• N = Near jack (J14)
• F = Far jack (J15)
• ? = No connection
The LCDs also indicate that judge consoles One and Six are currently operational—judge
console One is plugged into J14 , and judge console Six is plugged into J15 . The numbers
on the bottom row correspond to the key recently pressed on the judge console, to
help verify correct two-way communication. Test each judge console being used.
Press [ENTER] to exit. For more information on judge consoles, refer to Section 7: Judge
Consoles (p.83) .
CAN Network
This menu is used for advanced debugging by Daktronics service personnel only�
SB TEST MENU
3-DIGIT NUMBER
MENU-TEST
3-JUDGE CONSOLES
F ? ? ? ?
3