Daktronics OMNISPORT 2000, Operation Manual

Page: 91 / 182

Diving Mode Operation, Menus, & Settings
81
Pro Software Enable
This menu allows the operator to enable network
communications to Pro Diving software.
MENU-NETWORK
NETWORK PRO:ON *
From Main Menu – [4]>[6]>[7]
Use [←][→] to toggle between ON / OFF and then press [ENTER] to save.
Test Menu
The OmniSport 2000 timer is equipped with features that test
battery level, and the numeric scoreboard. The following
submenus explain how to use each of these tests. It is
important to run through these tests before the meet begins
to prevent problems from occurring during the meet.
Battery Test
This menu checks the battery power level.
BATTERY TEST
LEVEL= CHARGED
From Main Menu – [5]>[1]
BATTERY TEST
LEVEL= LOW
The battery level will show as CHARGED or LOW . Press [ENTER] to exit the menu.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
DISPLAY ALL ON
ENTER TO EXIT
From Main Menu – [5]>[2]>[1]
Press [1] to toggle the scoreboard ON and OFF . When this menu is selected, an all ON
signal is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on the
scoreboard are set to. The addresses were set when the
display was installed.
SHOWING ADDRESS
ENTER TO EXIT
From Main Menu – [5]>[2]>[2]
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
MENU-NETWORK
7-NETWK PRO/MMR
MENU-MAIN
5-TEST MENU
MENU-TEST
1-BATTERY
From Main Menu – [5]
MENU-TEST
2-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
From Main Menu – [5]>[2]
SB TEST MENU
2-DRIVER ADDRESS