Daktronics OMNISPORT 2000, Operation Manual

Page: 90 / 182

Diving Mode Operation, Menus, & Settings
80
Subnet Mask
The subnet mask may only be edited if the IP address is set to
custom. The default setting is shown below.
SUBNET MASK
255*255.255. 0
From Main Menu – [4]>[6]>[3]
Press the [0]–[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.
Gateway Address
The gateway address may only be edited if the IP address is
set to custom. The default setting is shown below.
GATEWAY ADDRESS
192.168. 0. 1
From Main Menu – [4]>[6]>[4]
Press the [0]–[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.
RTD Port Number
This menu allows the operator to set or verify the RTD port
number of the console. The default setting is shown below.
1-STD* 2-CUST
PORT#- 3002
From Main Menu – [4]>[6]>[5]
• In most cases, the standard RTD port number should be
selected. Press [1] .
• If the RTD will be sent to a Daktronics DVX/DVN video
display, press [1] followed by [ENTER] . The standard port
number will vary by console name as shown in the
table at right.
• If the RTD will be sent to a Daktronics Galaxy message
center, press [2] followed by [ENTER] . The standard port
number will always be “3002”.
• If a custom RTD port number is required, press [2] . Press
the [0]–[9] keys to enter a new value and press [ENTER] .
To select a standard port number instead, press [CLEAR]
twice to exit the menu.
MAC Address
This menu allows the operator to verify the MAC address of
the console. The MAC Address cannot be edited. Press any
key to exit the menu.
MAC ADDRESS
09:EC:03:01:06
From Main Menu – [4]>[6]>[6]
MENU-NETWORK
3-SUBNET MASK
MENU-NETWORK
4-GATEWAY ADDRES
MENU-NETWORK
5-RTD PORT #
1-DVX/N 2-GALXY*
PORT#- 3002
Name RTD Port #
OMNI1 21000
OMNI2 21001
OMNI3 21002
OMNI4 21003
CUSTOM
PORT#- 18000*
MENU-NETWORK
6-MAC ADDRESS