Daktronics OMNISPORT 2000, Operation Manual

Page: 75 / 182

Diving Mode Operation, Menus, & Settings
65
Fail & Balk
Fail and balk actions are only used when the score operation is active. If an official
determines that a diver balked on the dive or failed to perform the dive properly, the
judges are notified and the scores will be determined based on this. Pressing [BALK]
subtracts two points from each judges’ score. Pressing [FAIL] sets the awarded score to 0.
Note: The [FAIL] and [BALK] keys are only available after [SCORE] has been pressed the
first time and the judges’ scores are being entered. The center LCD shows FAIL or
BALK if this button has been pressed for the current diver.
Cut
When a diver is cut, that athlete will not be executing any dives in any future rounds.
The individual cut will be skipped when the console gets to that point in the Dive Order.
The results will show that individual’s score, up to the point
of being cut. Press [CUT] to toggle the cut setting. Verify a
diver’s cut status by looking at the first line of the left LCD,
next to the Diver #. If the diver is cut, the LCD will show (CUT) .
Next Event, Prev Event, & Event Heat
The OmniSport 2000 console has the capability of pre-programming an Event Order.
Refer to Edit Menu (p.69) .
Press [NEXT EVENT] to advance the console to the next event in the Event Order.
Press [PREV EVENT] to return the console back to the previous event in the Event Order.
Press [EVENT HEAT] to set the console to whatever event/
heat was entered. If that event is swimming, it will prompt
the user to switch. If the event is a diving event, it will set the
console to that Dive Order.
Pre-Event Setup
Clearing the Order
Before a new diving competition or event can be performed, the Dive Order must be set.
Clear any old information from the Dive Orders to eliminate any confusion that may arise.
Complete the following steps to clear the orders.
1� Press [SELECT ORDER]>[A] to set the current Dive Order to A.
2� Press [MENU]>[2]>[3]>[ENTER] to clear out Dive Order A.
3� Repeat Steps 1–2 for the [B] , [C] , and [D] Dive Orders.
Entering Dive Lists (Optional)
Each diver must perform certain dives during an event. The Dive List of each diver can
be stored in the Dive Orders. To enter the Dive List for each of the divers in Dive Order A,
follow the steps below:
1� Press [SELECT ORDER]>[A] to set the current Diver Order to A.
2� Verify on the left LCD that the Diver # and Round are both set to “01”.
3� Enter the first diver’s dive list by pressing [MENU]>[2]>[4]>[ENTER] .
4� The LCD will prompt the operator to enter the dive and position. Use the numeric
keypad to enter the three- or four-digit dive number and the [A] , [B] , [C] , and [D] keys
to select the position. Press [ENTER] to accept the dive and position.
DIVER# 05 (CUT)
ROUND:03 RANK:--
EVENT IS SWIM
SWITCH Y/N