Daktronics OMNISPORT 2000, Operation Manual

Page: 61 / 182

Swimming Mode Menus & Settings
51
RELAY TAKE-OFF
INPUT USED: 3*
Use [←][→] to select between input 1 , 2 , or 3 and then press [ENTER] to save and
advance to the next setting.
The relay take-off arm time is the amount of time that the console will look for an input
from the platform, after it has received a touchpad. This is used to filter out any garbage
data in case of teammates inadvertently bumping or slapping the top of the platform.
The arming time can be set from 0.1–1.5 seconds. A setting of 0.8 seconds works the best.
RELAY TAKE-OFF
ARM TIME:0.8SEC*
Press the [0]–[9] keys to enter the arm time and then press [ENTER] to save.
Note: Even with a correct arm time setting, it is very important that no one except the
competitor in the event touches the platform during relay events. The console
does not know the difference between the correct athlete, a teammate, or an
official leaning against the block.
Beeper Volume
This menu is for setting the internal beeper volume when keys
are pressed.
MENU-TIMER
BEEPER VOLUME:5
From Main Menu – [4]>[2]>[8]
Use [↑][↓] or the [0]–[7] keys to set the volume level, with 7 being the loudest setting, and
then press [ENTER] to save.
Setup Numeric Scoreboard Menu
This menu configures how the console will display data on a
Lane, Place, and Time numeric scoreboard.
Number of Lines
This menu sets the number of lines (1-10) of lane data that
the scoreboard will display. If the number of active lanes
in the pool is greater than the value set, the timer will
automatically page the information in place order. The
default is 10.
# OF LINES
LINES= ^8
From Main Menu – [4]>[3]>[1]>[1]
Press the [0]–[9] keys to enter the number of lines and then press [ENTER] to save.
MENU-TIMER
8-BEEPER VOLUME
MENU-SCOREBOARD
1-NUMERIC
From Main Menu – [4]>[3]
MENU-NUMERIC
1-# OF LINES