Daktronics OMNISPORT 2000, Operation Manual

Page: 146 / 182

Track Mode Menus & Settings
136
RTD Port Number
This menu allows the operator to set or verify the RTD port
number of the console. The default setting is shown below.
1-STD* 2-CUST
PORT#- 3002
From Main Menu – [4]>[6]>[5]
• In most cases, the standard RTD port number should be
selected. Press [1] .
• If the RTD will be sent to a Daktronics DVX/DVN video
display, press [1] followed by [ENTER] . The standard
port number will vary by console name as shown in the
table at right.
• If the RTD will be sent to a Daktronics Galaxy message
center, press [2] followed by [ENTER] . The standard port
number will always be “3002”.
• If a custom RTD port number is required, press [2] . Press
the [0]–[9] keys to enter a new value and press [ENTER] .
To select a standard port number instead, press [CLEAR]
twice to exit the menu.
MAC Address
This menu allows the operator to verify the MAC address of
the console. The MAC Address cannot be edited. Press any
key to exit the menu.
MAC ADDRESS
09:EC:03:01:06
From Main Menu – [4]>[6]>[6]
Meet Manager Enable
This menu allows the operator to enable network
communications to Meet Manager (results) software.
MENU-NETWORK
NETWORK MMR:ON *
From Main Menu – [4]>[6]>[7]
Use [←][→] to toggle between ON / OFF and then press [ENTER] to save.
Test Menu
The OmniSport 2000 timer is equipped with features that
test battery level, the lane modules, and the numeric
scoreboard. The following submenus explain how to use
each of these tests. It is important to run through these tests
before the meet begins to prevent problems from occurring
during the meet.
Battery Test
This menu checks the battery power level.
MENU-NETWORK
5-RTD PORT #
1-DVX/N 2-GALXY*
PORT#- 3002
Name RTD Port #
OMNI1 21000
OMNI2 21001
OMNI3 21002
OMNI4 21003
CUSTOM
PORT#- 18000*
MENU-NETWORK
6-MAC ADDRESS
MENU-NETWORK
7-NETWK PRO/MMR
MENU-MAIN
5-TEST MENU
MENU-TEST
1-BATTERY
From Main Menu – [5]