Daktronics OMNISPORT 2000, Operation Manual

Page: 139 / 182

Track Mode Menus & Settings
129
Use [←][→] to toggle the setting from N.O. to N.C. and then press [ENTER] to save.
Note: Normally Open (N.O.) is the standard setting for Daktronics timing accessories
with the OmniSport 2000 timer and is selected by default.
Primary Time
This menu will configure the console for which timing input(s)
to use as the primary time.
MENU-TIMER
INPUT= J7 1BTN*
From Main Menu – [4]>[1]>[3]
MENU-TIMER
INPUT= J10 3BTN*
Primary Time is used to tell the timer to use the J7 SWITCH INPUTS jack and 1 button per
lane for up to 8 lanes, or to use the J10 NEAR END jack 1, 2, or 3 buttons for up to 10 lanes.
Press [←][→] to toggle between settings:
• Input: J7 - 1 button
• Input: J10 - 1 button, 2 buttons, or 3 buttons
Press
[ENTER] to save or press [CLEAR] to exit without saving.
Note: When three buttons are used, final times are printed when the middle time is
received. If two buttons are being used, the time of the second button is printed
after both buttons are pressed. If one button is used, that is the time. In non-lane
events, only one button for lane one is used for all racers.
Precision
This menu tells the timer if it should report and display the
times to one hundredth (1/100) or one thousandth (1/1000)
of a second.
MENU-TIMER
PREC: 1/100 *
From Main Menu – [4]>[1]>[4]
Use [←][→] to select between 1/100 or 1/1000 , and then press [ENTER] to save.
Beeper Volume
This menu is for setting the internal beeper volume when keys
are pressed.
MENU-TIMER
BEEPER VOLUME:5
From Main Menu – [4]>[1]>[5]
Use [↑][↓] or the [0]–[7] keys to set the volume level, with 7 being the loudest setting, and
then press [ENTER] to save.
Setup Numeric Scoreboard Menu
This menu configures how the console will display data on a
Lane, Place, and Time numeric scoreboard.
MENU-TIMER
3-PRIMARY TIME
MENU-TIMER
4-PRECISION
MENU-TIMER
5-BEEPER VOLUME
MENU-SCOREBOARD
1-NUMERIC
From Main Menu – [4]>[2]