Daktronics OMNISPORT 2000, Operation Manual

Page: 130 / 182

Track Mode Operation
120
If an error is observed on the printout, use the [EDIT] key to make corrections. Press
[STORE PRINT] to verify the correction. After all corrections have been completed, press
[RESET]>[ENTER] . The timer is now ready to begin the next event.
The OmniSport 2000 printer uses the following symbols on its printouts to label data.
Symbol Definition
B(1-3)
Buttons 1 through 3
B or BK Backup time
E Edited time
M
Manual time
Edit
When the running time is counting, the [EDIT] key allows corrections to be made to times
in the current race memory. Press [EDIT] then the desired lane number key. Enter the new
time with the numeric keypad then press [ENTER] . Note that [EDIT] is disabled during non-
lane timing.
Paper Feed
Press [PAPER FEED] to have the printer advance the paper. The printer will not print on the
advanced lines.
Event Heat
• Event +1 : This function increments the event number by one.
• Heat +1 : This function increments the heat number by one.
• Heat -1 : This function decrements the heat number by one.
• Event Heat: Press [EVENT HEAT] to enter a particular event and heat number.
Place/Lane/Non-Lane Timing
• Lane Timing: Pressing [LANE TIMING] enables all lanes and buttons configured in
the system. When this is enabled, each lane has one to three push buttons that will
record when a racer finishes the race.
• Place Timing: Pressing [PLACE TIMING] enables all places and buttons configured
in the system. When this is enabled, each place has one to three buttons that will
record when a racer finishes the race.
• Non-Lane Timing: Pressing [NON-LANE TIMING] disables all of the buttons except Lane
1, Button 1. The official should press the button for every competitor finishing the race.
• Non-Lane Split Enable: [NON-LANE SPLIT ENABLE] uses the next button recorded to
calculate the cumulative and subtractive split for that last lap. The split time will be
printed and displayed on the scoreboard. The [NON-LANE SPLIT ENABLE] key only
works if the [NON-LANE TIMING] key has been pressed.
Reset
The timer is automatically reset when first turned on. The timer may be reset any time the
race clock is running by pressing [RESET]>[ENTER] .
When a race is complete, the operator presses [RESET]>[ENTER] to reset the timer.