Daktronics OMNISPORT 2000, Operation Manual

Page: 114 / 182

Water Polo Mode Operation, Menus, & Settings
104
Manual Horn
Pressing [HORN] will sound the horn. This key can be pressed at any time whether or not
the clock is counting.
Game Time Keys
The keys in the GAME TIME section control the main clock. This clock can be set to
count the period time, rest time, or overtime. One more setting to be aware of is the
Horn Control setting. This can be set so that the main clock horn and the shot time horn
are either tied together so that if either one sounds, they both sound, or they can be
independent.
Set Time
This key is used to set the time on the main clock. Pressing [SET TIME •] more than once
accesses the preset times. Read the right LCD to view the value the clock is being set to.
During any step, press [CLEAR] to exit. Note that the main clock must first be stopped to
edit the times.
• Press
[SET TIME •] once to view the current time on the clock. Press [ENTER] and use
the numeric keypad to input the desired time, and then press [ENTER] again to set the
time.
• Press [SET TIME •] twice to set the default period time. Press [ENTER] and use the
numeric keypad to change the main clock to the desired default period time, and
then press [ENTER] . This sets the main clock to the new period time and it changes the
default period time in the console’s stored memory.
• Press [SET TIME •] three times to set the Rest 1 time, which is typically the rest period
between quarters 1 and 2 or quarters 3 and 4. Press [ENTER] and use the numeric
keypad to change the default Rest 1 time, then press [ENTER] . This sets the new Rest 1
time in the main clock and the default time in the console’s stored memory.
• Press [SET TIME •] four times to set the Rest 2 time, which is typically the rest period for
half time and before overtime, if the match goes into overtime. Press [ENTER] and use
the numeric keypad to change the default Rest 2 time, then press [ENTER] . This sets
the new Rest 2 time in the main clock and the default time in the console’s stored
memory.
• Press [SET TIME •] five times to set the default overtime. Press [ENTER] and use the
numeric keypad to input the desired default overtime and then press [ENTER] . This
sets the main clock to the new overtime and it changes the default overtime in the
console’s stored memory.
Start
Press [START] to start the clock counting.
Stop
Press [STOP] to stop the clock.
Reset
Press [RESET] followed by [ENTER] to set the main clock to the default period time value.
To cancel resetting the clock, press [CLEAR] . The clock must be stopped otherwise the
[RESET] key will be ignored.