Daktronics FB-2006, Display Manual

Page: 22 / 76

16 Mechanical Installation
Before attaching the caption module, note its orientation. The top and bottom flanges
for holding the caption panel are different sizes. Be sure the module is oriented so
that the deeper flange, or guide, is toward the top.
The scoreboard modules are shipped with the 5" vinyl captions applied, but the
displays are also equipped with the guides needed for use with the optional custom
panels. To insert a caption panel, fit the top edge of the caption into the module's
upper guide, and then slide the bottom edge under the lower flange. Refer to
Drawing A-130840 . The construction of the flanges allows the caption panels to be
lifted out for changing, rather than having to slide them out one end.
The caption panels must be properly positioned in relation to the scoreboard digits
for different activities. Refer to the scoreboard options in
Appendix B for details on
changeable captions.
3.3 Mounting Digit Modules
Reference Drawings:
Beam Mounting Procedure .......................................... Drawing A-194664
Beam Mounting, Side View ......................................... Drawing A-194671
Beam Mounting, Top View .......................................... Drawing A-194674
Beam Mt., Rear, Vert. Display ..................................... Drawing A-194677
Scoreboard digit modules may be mounted directly to a wall, to universal mounting
struts (channels), or to some other support structure. Modular construction permits
varied configurations, and the unique requirements of each facility will determine the
setup and anchoring method best suited for the display. This manual addresses only
beam mounting.
Daktronics recommends using universal mounting struts, or channels. Use
3
/
8
" bolts
through the holes in both ends of the module frame. For displays with multiple digit
modules, mount the lowest module first and work upward.
Beam Mounting Digit Modules, Outdoor
Because every display is different in terms of module configuration, scoreboard
options, and environment, every installation will be unique. Such beam-mounted
installations require that a qualified engineer provide specifications for both the
reinforced concrete footings and the steel support beams. Two beams are required for
each column of display modules, and they must be set 4'-6" apart, center-to-center.
Installations of vertical displays are shown in
Drawing A-194677, which specifies
the overall space requirements for the scoreboards as well as their specific
dimensions.
Each digit module has knockouts in both the rear and the end for power and signal
entrance. Power and signal are brought into one module through these external
knockouts, and connections to other modules are made internally.