INSTALLATION INSTRUCTIONS
LAT-NR251
LED Tail Lights for 1968 Impala
MAN#650211
Kit Includes:
Installation:
1. Remove all tail light lenses as described below while taking care to keep
the lenses with their housings.
2. Remove the three screws that hold the lens in and remove the lens from
the housing.
3. Remove the light bulb from socket.
4. Now is a good time to clean the lenses and the tail light housings. If the
lenses are in poor condition a replacement set is recommended.
5. Make sure the housings and lenses are clean and dry. Test fit the LED
assemblies by placing the LED assemblies in housings to check for a good fit.
DO NOT
remove the backing from the tape yet!
Note the places where the tape touches the housing.
6. Squeeze the primer tube to break the glass bulb and wet the brush end with primer. Rub the
primer on the housings at the places where the tape will touch. Treat all tail light housings at
the same time before the primer tube dries out.
7. Wait for a minimum of 5 minutes for the primer to dry and cure.
