Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
12
REV122021
977701V
INSTALLATION OF DRILL BIT
A drill bit with a shaft of at least 1” long should be used to allow correct chuck jaw contact. If the
shaft is under 1” do not insert bit as far into the chuck where it allows jaw contact with the drill
flutes.
Center drill bit into the chuck and tighten the chuck securely with the chuck key.
Note: Always use sharp, straight bits. Never use bits with turned down shafts. Never exceed the
maximum shaft diameter bit size for the machine. All guards and interlocks must be in place
when operating the machine.
TOOLING REMOVAL
1. Before removing the chuck or bit form the machine be sure the spindle has come to
complete stop and power is off.
2. If needed rotate spindle by hand to align the spindle and quill openings.
3. Insert the wedge removal tool while supporting the tooling tap the wedge to remove the
tooling.
TABLE HEIGHT ADJUSTMENT
1. Loosen the clamp bolt then adjusting the table with the bracket handle to desired work
height.
2. Retighten the clamp securely when table is adjusted to desired height.
Note: Keep table adjustment rack clean from debris. Never attempt to move table with clamp
bolt tightened.
