Daitsu FDLA-09, Installation, Operation & Service Manual

Page: 138 / 322

Page 26 of 77
SK2019 FCSD(H)-V/P-ECM-001
•
The unit is fitted with a condensate pump with a maximum of 500mm lift.
•
The unit is provided with 25.4mm diameter ABS drainage outlet.
•
Confirm drain outlet has not been damaged before connecting drain pipe to unit.
•
Discharge pipe may be connected with hose clamp. (Figure B.7.1)
•
The drain must be installed with a downward slope.
•
Insulate drain pipe after installation.
Figure B.7.1
External Drain Pan Installation
1.
Align the two screw holes in the fixing plate to the two holes in the external drain pan. (Figure B.8.1 and B.8.2)
2. Make sure the drain pan is horizontal.
3. Tighten the two screws while making sure the external drain pan is installed flush against the fixing plate. (Figure B.8.3)
4. When the installation is completed, it is necessary to wrap the connecting pipe with thermal insulation to prevent
condensation on ceiling tiles.
Figue B.8.1 Figure B.8.2
Figure B.8.3
S LOPE
D0W N
50
0m
m
Caution
Factory-provided drain outlet is ABS. Using an unsuitable glue may damage the drainage
outlet.
External Drain Pan
Internal Drain Pan