Wired Remote Controller
ACCD_WC2
1
8
1
6
8
9
10
7
3
4
5
2
Fig.1
8
Fig.1
8
shows the installation steps of the wired remote controller, but there are some issues that need your attention.
(1). Prior to the installation, please firstly cut off the power supply of the wire buried in the
installation hole, that is, no operation is allowed with electricity during the whole installation.
(2). Pull out the four-core twisted pair line from the installation holes and then let it go through
the rectangular hole behind the soleplate of the wired remote controller.
(3). Stick the soleplate of wired controller on the wall and then use screw M4×25 to fix
soleplate and installation hole on wall together, attach the sponge 20×20×2 at the screw hole
and then press it with fingers to make sure it’s attached firmly.
(4). Insert the four-core twisted pair line into the slot of the wired remote controller and then
buckle the front panel and the soleplate of the wired remote controller together.
(5).
ST2.9X6.
Note
：
CN1 is 485 communication interface and it used
for connecting the 4-core communication wire.
These two needle stands(CN2
、
CN3) are used for
connecting the smart zone controller. There is no
sequence for these two needle stands. You can
connect one or two needle stand(s) basing on the
requirement.
