1.
Wrap paper template
around roller tube, the end you
want to install the Daisy Power
motor and controls
2.
Without the drive motor
inside the tube, mark and drill
the 6 x 4.5mm holes through
the template with the 4.5mm
drill bit (3 around the end of the
tube and 3 around the inside
of the tube approximately
243mm from end of tube)
3.
Insert the drive motor, (if
there is a feather plug in way,
remove, then replace after
motor install) then using the
4.5mm drill again, drill through
the 6 holes in the tube, through
the drive motor flange
daisy
P O W E R
daisy
pool covers & rollers
Installation
Instructions
Page 1