4123 Series User Manual
Supply Power Connection (100-240VAC)
D004-000017
31
8.1.1
Connecting KPT/KPSE Bayonet-style Quick Connect
The glandplates for models 4123AC, 4123AE, and 4123AF are equipped with a KPT/KPSE
bayonet-style male power connector. A female version of the same connector is needed to
connect to a 100-240VAC power source.
NOTE
The KPT/KPSE bayonet-style power connector needed to connect to a 100-
240VAC power source can be obtained from a
vendor of your choosing
. It can
also be purchased from Daisy Data Displays using part no. P130-000071-01.
Align the KPT/KPSE bayonet-style connectors so the female pin sockets align with the male
pins. Gradually push the female connector onto the pins while rotating the female connector
locking ring clockwise.
While rotating the locking ring, grooves in the ring will engage a set of pins on the outer
casing of the male connector and pull both connectors together. Continue turning the locking
ring until the pin engages (snaps into place), signifying a secure connection.
Figure 30 —
100-240AC Power Connected
8.2
Sealcon Cord Grip/Internal Power Connection
Two of the five Model 4123 Series configurations have the 100-240VAC power source connected
inside the unit enclosure. The power source cable passes through the enclosure via an Sealcon Cord
Grip installed on the glandplate and attaches to a power terminal block.
This requires the removal of the glandplate, then passing the power source through the cord grip and
glandplate and attaching it to the power source terminal mounted in the enclosure.
The models are (Model/Glandplate No.):
•
Model 4123 (I640-002303)
•
Model 4123AD (I640-002322)
Figure 31 — Power Supply connected through Sealcon Cord Grip
