Daimler Freightliner Cascadia 2021, Driver Manual

Page: 181 / 322

America LLC (DTNA) urges that the driver and all
passengers, regardless of age or physical condition,
use seat belts when riding in the vehicle.
WARNING
Always use the vehicle’s seat belt system when
operating the vehicle. Failure to do so can result
in severe personal injury or death.
Seat belt assemblies in DTNA vehicles meet Federal
Motor Vehicle Safety Standard 209, "Type 1" and
"Type 2" requirements.
When transporting a child, always use a child re-
straint system or the vehicle seat belts as appropri-
ate. To determine whether a child restraint system is
required, review and comply with applicable state
and local laws. Any child restraint used must comply
with Federal Motor Vehicle Safety Standard 213,
"Child Restraint Systems." When providing a child
restraint system, always carefully read and follow all
instructions pertaining to installation and usage for
the child. Make certain the child remains in the re-
straint system at all times when the vehicle is in
motion.
In addition to seat belt assemblies, tether belts are
installed on suspension-type seats. Tether belts help
secure the seat to the floor and are intended to re-
strain the seat and seat belt in case of an accident or
sudden stop.
IMPORTANT: Seat belts have a finite life which
may be much shorter than the life of the vehicle.
Regular inspections and replacement as needed
are the only assurance of adequate seat belt
security over the life of the vehicle.
Seat Belt Inspection
WARNING
Inspect and maintain seat belts. When any part of
a seat belt system needs replacement, the entire
seat belt must be replaced, both retractor and
buckle side. Any time a vehicle is involved in an
accident, and the seat belt system was in use,
the entire vehicle seat belt system must be re-
placed before operating the vehicle. Do not at-
tempt to modify the seat belt system; doing so
could change the effectiveness of the system.
Failure to replace worn or damaged seat belts, or
making any modifications to the system, may re-
sult in personal injury or death.
Inspect the seat belts and tether belts (if so
equipped).
1. Check the web for fraying, cuts, extreme dirt and
dust, or for severe fading from exposure to sun-
light, especially near the buckle latch plate and in
the D-loop guide area.
2. Check operation of the buckle, latch, Komfort
Latch or Sliding Komfort Latch (if equipped), web
retractor, and upper seat belt mount on the door
pillar. Check all visible components for wear or
damage.
3. Check the seat belt and tether belt connection
points and tighten any that are loose.
Seat Belt Operation
When engaged and used properly, the Komfort Latch
(
Fig. 9.6 ) and the Sliding Komfort Latch ( Fig. 9.7 )
introduce a small amount of slack into the seat belt,
resulting in a more comfortable ride.
1. Slowly pull the link end of the seat belt out of the
retractor and pull it across your lap (from out-
board to inboard) far enough to engage the
buckle. If the retractor locks too soon, allow the
belt to retract slightly, then slowly pull it out
again. See
Fig. 9.8 .
2. Fasten the seat belt by pushing the latch into the
buckle. Listen for an audible click.
3. Tug on the seat belt to make sure it is securely
fastened. If the buckle unlatches, repeat this
step. If the problem continues, replace the seat
belt.
4. Snug the seat belt to your waist.
10/15/2007 f910599
A
B
A. Squeeze the fore-and-aft slide lock against the
adjustment bail.
B. Lift up the adjustment bail.
Fig. 9.5, Fore/Aft Slide Adjustment, Sears Atlas Seat
Seats and Restraints
9.4