Daikin VRV II RXYQ8MY1K, Service Manual

Page: 105 / 310

Field Setting Si39-502A
94 Test Operation
3. Field Setting
3.1 Field Setting from Remote Controller
Individual function of indoor unit can be changed from the remote controller. At the time of
installation or after service inspection / repair, make the local setting in accordance with the
following description.
Wrong setting may cause malfunction.
(When optional accessory is mounted on the indoor unit, setting for the indoor unit may be
required to change. Refer to information in the option handbook.)
3.1.1 Wired Remote Controller <BRC1A61, 62>
1. When in the normal mode, press the “ ” button for a minimum of four seconds, and the
FIELD SET MODE is entered.
2. Select the desired MODE NO. with the “ ” button (
���
).
3. During group control, when setting by each indoor unit (mode No. 20, 22 and 23 have been
selected), push the “ ” button (
���
) and select the INDOOR UNIT NO to be set. (This
operation is unnecessary when setting by group.)
4. Push the “ ” upper button (
���
) and select FIRST CODE NO.
5. Push the “ ” lower button (
���
) and select the SECOND CODE NO.
6. Push the “ ” button (
���
) once and the present settings are SET.
7. Push the “ ” button (
���
) to return to the NORMAL MODE.
(Example)
If during group setting and the time to clean air filter is set to FILTER CONTAMINATION,
HEAVY, SET MODE NO. to “10” FIRST CODE NO. to “0”, and SECOND CODE NO. to “02”.