Daikin VAM 1000FAVE, Service Manual

Page: 33 / 84

Control Functions SiE71-202
24 Control Functions
2) Link control of 2 or more groups (zone link)
Heat recovery ventilation unit can be operated when one or more air conditioners are operating.
Allows independent operation of heat recovery ventilation unit from VRV-system remote controller
during interim periods (direct duct connection is not allowed in this system).
ON/OFF operation is not possible from LCD remote controller of heat recovery ventilation unit.
Note: With Super Wiring, units of different outdoor systems can be linked in operation.
1.2.5 Field Setting, Service Mode
1. Field setting
Used for initial setting of heat recovery ventilation unit.
2. Service mode
Used for confirmation of unit Nos. in the group and reallocation of unit Nos.
List of Field Setting and Service Mode
Group
1
Group
2
(HL025)
Group
3
Adapter PCB
for remote control
(KPR2A61)
Remote controller
for air conditioner
Remote controller
for air conditioner
Remote controller
for air conditioner
Details of setting Mode Setting
mode
Setting
switch
No.
Setting position Operation method
01 02 03 04 05 06
Group No. setting
for centralized
controller
(individual) Field
setting 00(30)
Refer to P55
Filter cleaning
time setting 17(27) 0 Approx.
2500 hr.
Approx.
1250 hr.
No counting
— — —
Refer to P54
Pre-cool/pre-heat
On/Off setting 2 Off On — — — —
Pre-cool/pre-heat
time (min.)
setting 3 30 min. 45 min. 60 min. — —
Fan speed initial
setting 4 Normal Ultra-High — — — —
Yes / No setting
for direct duct
Connection with
VRV system 5 No duct
(Air flow
setting)
With duct
(fan off)
— — — —
Setting for cold
areas
(Fan operation
selection for
heater
thermostat OFF) — — No duct With duct
Fan off Fan L Fan off Fan L
Centralized /
individual setting 7 Centralized Individual — — — —
Centralized zone
interlock setting 8 No Yes Priority on
Operation — — —
Pre-heat time
extension setting 9 0 30 min. 60 min. 90 min.
— —
External signal
setting JC / J2 18(28) 0 Last
command Priority on
external
input — — — —
Setting for direct
power-on 1 Off On — — — —
Auto restart
setting 2 Off On — — — —
External
damper
operation
Refer to P26
3
— —
On
— — —