27
Troubleshooting
Air purifying function
Phenomenon
Check points
Air purifying capacity is reduced
•
Is the unit surrounded by obstacles, or positioned in a place where
airflow cannot reach?
¼
Choose a position that is obstacle-free and from where airflow can
reach all areas of the room.
•
Is the pre-filter or dust collection filter dirty?
¼
Clean these parts.
►
Page 19, 20
The air outlet is emitting an odour
•
Is the deodorising filter dirty?
¼
Clean the parts.
►
Page 20
• In some cases the air outlet may emit a slight odour as trace amounts of
ozone are generated. However, the amount is negligible and is not harmful
to your health.
•
Is the room filled with odours due to cooking or several people
smoking together etc?
¼
The odour will gradually fade as the unit operates.
•
Have you moved the unit from another room?
¼
The unit may emit the odour of the room in which it was used previously.
Let the unit run a while longer.
•
Is there anything in the room that is emitting an odour continuously?
(Paint, new furniture, wallpaper, sprays, cosmetics, chemicals)
¼
As continuously emitted odours cannot be completely eliminated, you
should ventilate the room at the same time or run the unit in a well-
ventilated room for a short while.
No air is being emitted
•
Is the air outlet or an air inlet blocked?
If they are not blocked, an electrical component is faulty.
¼
Contact the place of purchase.
Other
Phenomenon
Check points
The fan stops midway through unit
operation
• When the unit switches to Monitoring mode during operation in ECONO
MODE, the fan turns on and off repeatedly.
►
Page 14
•
Are the pre-filter, outflow grille, and dust collection filter attached
before the unit is operated?
The fan is configured to stop in order to protect electrical components
if a part is not properly attached.
¼
If a part is not attached, unplug the unit and attach all the parts before
turning the unit on again.
The sound of streamer discharge can
no longer be heard
• Depending on the degree of air impurity, streamer operation may turn OFF.
►
Page 16
•
Is streamer output set to Low?
►
Page 16
There is interference on our TV
screen
•
Is the TV or radio positioned within 2m of the unit, or is an indoor
antenna positioned near the unit?
•
Are the power supply cord or antenna cable of the TV or radio routed
near the unit?
¼
Keep the unit as far as possible from the TV, radio or antenna.
Just inserting the power supply plug
causes operation to start
•
Did you disconnect the power supply plug during a power failure, or
when a sudden voltage fluctuation occurred? Or did you stop the unit
by disconnecting the power supply plug during the last operation?
¼
The auto-restart function automatically resumes operation.
Troubleshooting
01_EN_3P595629-1B.indd 27
2020/04/17 16:01:58
