21
Maintenance
WARNING
Before cleaning and maintenance work, be sure to unplug
the unit. (An electric shock or injury may result)
Maintenance
Streamer Unit
Replace
If the streamer lamp blinks
Basically, the streamer unit will not need to be replaced. However, depending on the location the
unit is used (places where oils are present, or dust and humidity is abundant, or sprays and
chemical agents are used, etc.), replacement may become necessary.
►
Page 23
Contact the place of purchase.
1.
Remove the pre-filter on the left side viewing
from the back of the main unit.
►
Page 19
2.
Flip up the protective covers and remove the
streamer unit cover.
Streamer unit cover
(black)
Viewed from rear
Place your finger on the hook
and pull it towards you.
Protective covers
(transparent)
Removing
the protective
covers is
unnecessary
Hook
3.
Remove the streamer unit.
1
Remove the streamer unit connector.
1. Push the hook on the connector
2. Pull it out while pushing the hook
The lock will not release unless the
hook is pushed
(Breakage may result from forcibly
pulling)
2
1
Connector
Hook
2
Push in the left side of the streamer unit so the right
side comes out.
You will hear a
catching sound
3
Remove the streamer unit.
4.
Flip up the protective covers and attach the
new streamer unit.
1 First insert the streamer unit to the left, then push the
right side until the hook makes a catching sound.
Catching sound
2 Pay attention to the direction of the hook on the
connector, making sure it is facing to the right, and
fully insert the connector.
5.
Flip up the protective covers and attach the
streamer unit cover.
Push until you
hear a catching
sound
Secure the hooks (2 places)
on the left side of the streamer
unit cover
Hooks
• Ensure you don’t trap the connector cord.
• If the streamer unit cover is not properly attached the
safety switch will engage, and the unit cannot operate.
6.
Attach the pre-filter.
►
Page 19
7.
Insert the power supply plug while pressing
on the unit, and wait until a short beep
sounds.
• The streamer lamp will turn off.
• If you release
and attempt operation before the
short beep sounds, the streamer lamp will blink again.
• If you perform this step and the streamer lamp still blinks,
check that the connector is properly inserted.
01_EN_3P595629-1B.indd 21
2020/04/17 16:01:56
