6
|
Operation
User reference guide
35
ATXM20~3 ATXM5 ATXM20~35R5V1B
Daikin room air conditioner
4P518786-6F – 2020.06
2
Search for Daikin Residential Controller.
3
Follow the directions on the screen to install.
6.12.3 To set the wireless connection
There are two options to connect the wireless adapter with your smart device.
▪
Connect the wireless LAN to your smart device directly.
▪
Connect the wireless LAN to your home network.
The wireless LAN will
communicate with your smart device in your home network using a modem,
router or a similar device.
For more information and FAQ refer to:
http://www.onlinecontroller.daikineurope.com/
.
1
Stop operation before setting the wireless connection.
2
Use the user interface to select the wireless LAN setting menu.
Note:
Always aim the user interface at the signal receiver on the unit when
operating the user interface.
Menu
Description
Connection status check
WPS connection setting
AP mode/RUN mode (SSID + KEY) connection setting
Reset to factory default
Wireless LAN OFF
To confirm the wireless LAN connection status
1
On home screen menu, press and hold
for at least 5 seconds while the unit
is not operating.
Result:
The SP (wireless connection setting menu) appears. is blinking.
(5 sec.)
2
Press
to confirm the selection.
Result:
is blinking.
3
Check the operation and timer LEDs on the indoor unit display.
ON/
OFF
a
b
a
Operation LED
b
Timer LED
If operation LED… …and timer LED…
…then wireless LAN is…
blinks
blinks
not connected