Daikin SEER 14, Data Manual

Page: 174 / 178

EDUS041111_a Optional Accessories
Room Air Conditioners K-Series 173
13.6 <KPW937B4> Air Direction Adjustment Grille
Before Installation
N ame
Shape
1piece
Lo uv er Scre w s M4×30L
4pieces
Installation man u al
1piece
1. Install so that a short circ u it is pre v ented.
2. For the u se in sno w y regions, a v oid installation w ith the air o u tlet facing u p w ard. Install so that the air o u tlet faces
left w ard, right w ard, or do w n w ard.
Sno w acc u m u lates in the air o u tlet of the o u tdoor u nit, ca u sing malf u nction of the main b ody of the o u tdoor u nit.
3. Be ad v ised that if the fan direction is u p, dead lea v es and other foreign matter easily acc u m u lates in the exha u st v ent.
4. Do not u se any scre w s other than those incl u ded.
The prepared hole is
in the front panel.
Prepared hole
Prepared hole
Part A “prepared hole portion” cross-section
(The prepared hole does not go thro u gh.)
Prepared hole
pitch 17-1/
8
”(435mm)
Fan partitio
n
Prepared hole
pitch 435mm
Fan partition
Q u antity
Use when installing in a location that meets the following conditions.
W hen installing near the b order to a neigh b or’s ho u se
If exha u st b lo w s directly on passers- b y b eca u se o u tdoor u nit is installed facing a road.
Changing the fan direction of the o u tdoor u nit to pre v ent it b lo w ing directly on shr ubb ery, etc.
Installation is possi b le in the fo u r directions: u p w ard, do w n w ard, right w ard, and left w ard.
First temporarily attach the lo uv er w ith 4 scre w s, then check that the angle is correct, and finally tighten the scre w s f u lly .
Part A
(see fig u re b elo w )
Part B
(see fig u re right)
Installation Procedure
Prepared hole
pitch 435mm
Fan partition
Prepared hole
pitch 17-1/
8
”(435mm)
Fan partition
Use of an electric
scre
w dri v er is
recommended.
Do not open a hole in the prepared hole portion w ith
a b orer, since this w ill damage internal parts.
Do not u se an electric
scre w dri v er.
<For models with round outlet vents> <For models with square outlet vents>
a)
Grille grating
b )
Grille grating
The prepared hole is approximately
5/
8 ”(15mm) b ack from the s u rface
b et w een the b ars of the grille.
( Part B )
The cross-section comes in
t
w o shapes, a) and b ).
Prepared hole
Checking the parts
Selection of Installation Location
Installation of Louver
Check the follo w ing parts
CAUTION
4P202735-1