SiSG121917E
Field Settings
Part 7 Trial Operation and Field Settings
198
5.2.4 Address and MAIN/SUB Setting for Wireless Remote Controller
Outline
When several wireless remote controller units are used together in the same room, including the
case where both group control and individual remote controller control are used together, be
sure to set the addresses for the receiver and wireless remote controller.
For group control, see the attached installation manual for the indoor unit.
If using both wired and wireless remote controller for 1 indoor unit, wired remote controller
should be set to MAIN. Therefore, set MAIN/SUB switch (SS1) on the signal receiver PCB to
SUB.
If controlling with 1 remote controller, be sure to set it to MAIN.
Set the remote controller before turning power supply on.
Signal Receiver
PCB Setting
FDMR Series
Set the MAIN/SUB setting switch (SS1) on the signal receiver PCB to SUB.
Set the address setting switch (SS2) on the signal receiver PCB according to the table below.
Wireless Remote
Controller Setting
(Factory Set is 1)
1. Open the cover on the display of the wireless remote controller.
2. Press
FILTER SIGN RESET
button and
INSPECTION
button at the same time for 4
seconds or more to go into the FIELD SETTING mode.
The liquid crystal display on the remote controller is shown below illustration.
3. Press
SELECT
button and select the multiple setting. (A/b setting)
Each time the button is pressed, the display changes from “A” to “b”.
4. Press
TEMP
buttons for set the address.
The address can be set from 1 to 6, but set it from 1 to 3 to correspond with the receiving
part. It does not work when it is set from 4 to 6.
MAIN
SUB
MAIN/SUB setting
switch (SS1)
Unit No.
No.1
No.2
No.3
Address setting
switch (SS2)
Setting the recei
v
er
(lt is factory set to “1”)
Address setting s
w
itch (SS2)
MAI
N
/SUB setting s
w
itch (SS1)
(R24951)
M
S
M
S
1
SS2
2
3
1
SS2
2
3
1
SS2
2
3
1
2
3
4
5
6
