Daikin homecontrols EKRSENDI1BA, Installer And User Manual

Page: 15 / 28

15
Start-up Start-up
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents and not too cold to ensure long-time adher-
ence.
2. Fix the adhesive strips (E) on the back side of
the mounting plate (D) in the provided area. You
should be able to read the letters on the back side
(F) (
see figure 4
).
3. Remove the protective film from the adhesive strip.
4. Press the assembled DHC Room Sensor with the
back side to the wall.
5.2.2 Screw mounting
To mount the DHC Room Sensor with screws, proceed as
follows:
1. Choose a site for installation.
Make sure that no electricity or similar lines run in
the wall at this location!
2. Position the mounting plate (D) on the desired site
on the wall. Make sure that the arrow on the back
side of the mounting plate is pointing upwards.
3. Use a pen to mark the positions of the screw holes
(H) (diagonally opposite) according to the moun-
ting plate on the wall (
see figure 5
).
4. Drill the marked holes.
If you are working with a stone wall, drill the marked
5 mm holes and insert the plugs supplied. If you are
working with a wooden wall, you can pre-drill
1.5 mm holes to easier insert the screws.
5. Use the supplied screws and plugs (I) to fix the
mounting plate to the wall (
see figure 6
).
6. Attach the clip-on frame (A) to the mounting plate.
7. Place the DHC Room Sensor (B) into the frame
( see figure 1 ). Make sure that the clips on the
mounting plate latch into the openings on the DHC
Room Sensor.
5.2.3 Flush-mounted box mounting
You can mount the DHC Room Sensor on a flush-mounted
box using the screw holes (G) ( see figure 5 ).
If the accessory is mounted to a flush-mounted
box, there may be no open conductor ends.
If changes or works have to be made on the house
installation (e.g. extension, bypass of switch or
socket inserts) or the low-voltage distribution for
mounting or installing the accessory, the following
safety instruction must be considered: