Daikin Home Controls EKRRVATR2BA, User Reference Manual

Page: 33 / 40

33
Troubleshooting Restore factory settings
Error and
flashing
codes
Meaning Solution
Fast orange
flashing
Direct connec-
tion mode active
Activate the con-
nection mode of the
accessory you want
to connect (see the
DHC Application
Guide).
Short orange
lighting (after
green or red
confirmation)
Batteries empty Replace the
batteries (see “8
Replacing batteries”
on page 26 ).
6x long red
flashing
Accessory
defective
Contact your
reseller.
1x orange
and 1 x green
lighting (after
inserting bat-
teries)
Test LED After the test LED
has stopped, you
can continue.
Long and short
orange flashing
(alternating)
Update of
accessory soft-
ware (OTAU)
Wait until the update
is completed.
10 Restore factory settings
The factory settings of the accessory can be re-
stored. If you do this, you will lose all your settings.
To restore the factory settings of the accessory, proceed
as follows:
1. Open the battery compartment (B) by pulling the
battery compartment down (see figure 3) .
2. Remove a battery.
3. Insert the battery again and long press the system
button (D) at the same time until the LED quickly
starts flashing orange.
4. Release the system button.
5. Long press the system button again, until the LED
lights up green
6. Release the system button to finish the procedure.
» The accessory will perform a restart.