Daikin FXUA100AVEB, Installer And User Manual

Page: 34 / 88

10 | Maintenance and service
Installer and user reference guide
34
FXUA50~100AVEB
VRV system air conditioner
4P673843-1 – 2022.01
a
a
a Knobs
2 Remove the suction grille. Unhook the 4 straps from the indoor unit. Open
the suction grille in a 45° angle and unhook it from the hooks (3 places).
45°
3
1
2
3 Remove the air filter. Refer to "10.2.2 To clean the air filter" [
4
32].
4 Clean the suction grille. Wash with a soft bristle brush and water or neutral
detergent. If the suction grille is very dirty, use a typical kitchen cleaner, leave
it on for 10 min, then wash it with water.
5 Reattach the air filter. Refer to "10.2.2 To clean the air filter" [
4
32].
6 Reattach the suction grille and close it. (steps 2 and 1 in reverse order).
INFORMATION
When closing the suction grille, make sure the straps of the suction grille are not
pinched anywhere.
10.3 Maintenance before a long stop period
E.g., at the end of the season.
▪ Let the indoor units run in fan only operation for about half a day in order to dry
the interior of the units.
▪ Clean air filters and casings of indoor units (see "10.2 Cleaning the unit exterior,
air filter and suction grille" [
4
32]).
▪ Remove the batteries from the user interface (if applicable).
10.4 Maintenance after a long stop period
E.g., at the beginning of the season.
▪ Check and remove everything that might be blocking inlet and outlet vents of
indoor units and outdoor units.
▪ Clean air filters and casings of indoor units (see "10.2 Cleaning the unit exterior,
air filter and suction grille" [ 4 32]).
▪ Insert batteries in the user interface (if applicable).