9 Wireless LAN adapter installation
Installation manual
13
FTXTP-M_FTXTP-N
Daikin room air conditioner
3P650253-16U – 2023.03
8.2
To pass the pipes through the wall
hole
1
Shape the refrigerant pipes along the pipe path marking on the
mounting plate.
a
b
c
c
d
e
a
Drain hose
b
Caulk this hole with putty or caulking material
c
Adhesive vinyl tape
d
Insulation tape
e
Mounting plate (accessory)
NOTICE
▪ Do NOT bend refrigerant pipes.
▪ Do NOT push the refrigerant pipes onto the bottom
frame or the front grille.
2
Pass the drain hose and refrigerant piping through the wall hole
and seal the gap with a putty.
8.3
To fix the unit on the mounting
plate
1
Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
2
Press the bottom frame of the unit with both hands to set it on
the bottom hooks of the mounting plate. Make sure that the
wires do NOT get squeezed anywhere.
Note:
Take care that the interconnection cable does NOT get
caught in the indoor unit.
3
Press the bottom edge of the indoor unit with both hands until it
is firmly caught by the mounting plate hooks.
4
Secure the indoor unit to the mounting plate using 2 indoor unit
fixing screws M4×12L (accessory).
9
Wireless LAN adapter
installation
▪ Wireless LAN adapter is part of the accessory bag.
9.1
To install the adapter
DANGER: RISK OF ELECTROCUTION
▪ Turn off the power supply before installing the adapter.
▪ Do NOT handle the adapter with wet hands.
▪ Do NOT let the adapter get wet.
▪ Do NOT disassemble, modify or repair the adapter.
▪ Grip the connector when disconnecting the connecting
cord.
▪ Turn off the power supply in case the adapter gets
damaged.
9.1.1
To connect the adapter with the unit
1
Remove the tape holding the connecting cord connector.
a
a
Tape
2
Cut the clip and remove the connector from the protection
sleeve.
b
a
a
Protection sleeve
b
Clip
3
Remove the upper case of the wireless LAN adapter.
a
c
b
a
Upper case
b
Printed circuit board of the wireless LAN adapter
c
Lower case
4
Attach the connecting cord connector (white).
a
a
Connector
5
Fasten the connecting cord to the notch in the adapter case
(lower). Ensure that external force is not transmitted.
