Daikin FTXG20LV1BW, Service Manual

Page: 83 / 128

SiBE041401E Troubleshooting
Service Diagnosis 72
4.11 Outdoor Unit PCB Abnormality
Error Code
E1
Method of Error
Detection
„
The system checks if the microprocessor is working in order.
„
The system checks if the zero-cross signal comes in properly.
Error Decision
Conditions
„
The microprocessor program runs out of control.
„
The zero-cross signal is not detected.
Supposed
Causes
„
Defective outdoor unit PCB
„
Broken harness between PCBs
„
Noise
„
Momentary drop of voltage
„
Momentary power failure
Troubleshooting
Caution
Be sure to turn off the power switch before connecting or disconnecting
connectors, or parts may be damaged.
NO
YES
YES
(R19932)
NO
YES
NO
Replace the outdoor unit
PCB (2).
Ground the system.
Zero-cross signal
abnormality.
Replace the outdoor unit
PCB (1).
Replace the harness.
Check if the outdoor unit is
grounded.
Is LED A blinking?
Grounded?
Is the harness
broken?
Turn on the power again.
∗
Before you check the LED A,
cancel the standby electricity
saving function by starting fan
operation with the remote
controller.
∗
Wait at least for 7 sec. after
turning on the power.