Daikin FTK18NMVJU, Service Manual, Page: 8 / 22

Electrical Box / Swing Motor Si041553EB
6 Removal Procedure
5. Electrical Box / Swing Motor
Warning
Š
Be sure to wait for 10 minutes or more after turning off all power supplies before
disassembling work.
Step Procedure Points
1. Disconnect the
connecting wire.
„
The service cover can be
removed without removing
the front grille.
„
The service cover has no
hook and may fall when the
screw is loosened. Be
careful not to drop the
service cover.
1 Remove the screw, and
then the service cover.
2
3
4
Remove the screw, and
then the wire fixture.
Remove the screw, and
then the conduit holding
the connecting wire.
Remove the 4 screws
of the terminal board
and disconnect the
connecting wire.
„
Conduit is only for U.S.
models.
2. Remove the electrical
box.
„
When reassembling, be sure
to insert the earth/ground
wires in the front slit and
green/yellow wire is above
the green wire.
„
When reassembling, make
sure to pass the green earth/
ground wire behind the heat
exchanger tube (the tube
with the thermistor).
1
2
Remove the 2 screws
and detach the earth/
ground wires.
Release the earth/
ground wires from the
front slit at the top of the
electrical box.
Service cover
(R21502)
Wire fixture Conduit
Terminal board
Connecting
wire
(R21503)
Electrical
box
Front slit Earth/ground wire (green/yellow)
Earth/ground wire (green)
(R24272)
Green/yellow
Green
(R24275)