Daikin F-Series, Service Manual

Page: 178 / 355

SiBE12-713 Instruction
Operation Manual 167
FTXG 25/35 E, CTXG 50 E
Care and Cleaning
CAUTION
„
Indoor unit, Outdoor unit and Remote controller
1. Wipe them with dry soft cloth.
„
Front panel
1. Open the front panel.
• Open the front panel by placing a finger on the
panel tab on either side of the front panel.
2. Remove the front panel.
• With the front panel open so that it is almost hori-
zontal, slide it to the right.
The revolving axis on the left will come off.
The revolving axis on the right can be removed by
sliding the front panel to the left.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the front panel with water, dry
it with cloth, dry it up in the shade after washing.
4. Attach the front panel.
• Place the revolving axes on either side of the front
panel into the holes and slowly close.
(Press either side of the front panel.)
CAUTION
Units
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the front panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40
°
C, benzine, gasoline, thinner, nor other volatile oils, pol-
ishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
• Before cleaning, be sure to stop the operation and turn the breaker OFF.
• Always shut down the unit (and close the panel) before doing any work.
Opening the panel during operation may cause the panel to fall off.