Daikin EKSR3PA, Operating And Installation Instructions

Page: 6 / 40

1 x Safety
Operating and installation instructions
6
E EKSRDS1A
Control and pump unit for solar systems
4PW56033-1
1.3 Avoid danger
Daikin solar installations are state-of-the-art and are built to meet all recognised technical requirements. However, improper use
can lead to serious injuries or death, as well as cause material damage. To prevent such risks, install and operate the Daikin solar
installation only:
– as stipulated and in perfect condition,
– with an awareness of the safety and hazards involved.
This assumes knowledge and use of the contents of this manual, the relevant accident prevention regulations and the recognised
safety-related and occupational medical rules.
1.4 Proper use
The Daikin solar installation must only be used for heating hot water. The Daikin solar system must be installed, connected and
operated only according to the instructions in this manual.
Any other use outside the above-mentioned use is considered as improper. Any resulting damages will be borne by the user/owner
alone.
Proper use also includes observing the relevant maintenance and servicing conditions. Spare parts must at least satisfy the
technical requirements defined by the manufacturer. This is the case, for example, with original spare parts.
1.5 Instructions for operating safety
Working on the roof
• Installation work on the roof may only be carried out by authorised and trained persons (heating technicians, roofers, etc.) in
compliance with the relevant Accident Prevention Regulations.
• Material and tools must be secured against falling down.
• Barriers must be erected to prevent persons from entering the area below the roof where the work is being carried out.
• Observe safety clearances to overhead lines at the installation location.
Before working on the heating system
• All work on the heating system (such as installation, connection, and start-up) may only be carried out by authorised and
trained heating technicians.
• Switch off the mains supply before starting any work on the heating system and secure it against unintentional switch-on.
Electrical installation
• Electrical installation may only be carried out by qualified electrical technicians under observance of the relevant electrical
guidelines and the regulations of the electric utilities company.
• Before connecting to the mains supply, check that the voltage specified on the type label of the heating system (230 V,
50 Hz) is the same as the available supply voltage.
Instructing the user/owner
• Before you hand over the heating system, explain to the user/owner how to operate and check the heating system.