![background image](http://html1.mh-extra.com/html/daikin/ekhbrd014abv1/ekhbrd014abv1_operation-manual_4704498016.webp)
Operation manual
15
EKHBRD011~Y1
Indoor unit for air to water heat pump system and options
4PW60971-1
Field settings
The con
fi
guration of the Daikin system is done through
fi
eld settings.
In this operation manual all
fi
eld settings related to the operation of
the unit and user demand are explained. A list of all those
fi
eld
settings and default values is given under "Field settings table" on
page 16. In this same list, we provided for 2 columns to register the
date and value of altered
fi
eld settings at variance with the default
value.
For a total list of
fi
eld settings, refer to the installation manual.
All
fi
eld settings are accessible and programmable through the user
interface on the indoor unit.
Each
fi
eld setting is assigned a 3-digit number or code, for example
[5-03], which is indicated on the user interface display. The
fi
rst digit
[5] indicates the '
fi
rst code' or
fi
eld setting group. The second and
third digit [03] together indicate the 'second code'.
Procedure
To change one or more
fi
eld settings, proceed as follows.
1
Press the
z
button for a minimum of 5 seconds to enter FIELD
SET MODE.
The
$
icon (3) will be displayed. The current selected
fi
eld
setting code is indicated
;
(2), with the set value displayed to
the right
-
(1).
2
Press the
ébi
button to select the appropriate
fi
eld setting
fi
rst code.
3
Press the
ébj
button to select the appropriate
fi
eld setting
second code.
4
Press the
pfi
button and
pfj
button to change
the set value of the select
fi
eld setting.
5
Save the new value by pressing the
pr
button.
6
Repeat step 2 through 4 to change other
fi
eld settings as
required.
7
When
fi
nished, press the
z
button to exit FIELD SET MODE.
NOTE
Changes made to a speci
fi
c
fi
eld setting are only
stored when the
pr
button is pressed. Navigating to a
new
fi
eld setting code or pressing the
z
button will
discard the change made.
NOTE
■
Before shipping, the set values have been set as
shown under "Field settings table" on page 16.
■
When exiting FIELD SET MODE, "
88
" may be
displayed on the remote controller LCD while the
unit initializes itself.
2
3
1
When running through the
fi
eld settings you may notice
that there are some more
fi
eld settings as there are
mentioned in the "Field settings table" on page 16.
These
fi
eld settings are not applicable and may not be
changed!