25
10.3 Setting the Cool/Heat selection eligibility (VRV only)
Setting Changes
Refer to “Cool/Heat selection eligibility” on page 26 for an explanation of the
Cool/Heat selection eligibility.
1
•
Press the Mode Selector button (
) on the
remote controller that has Cool/Heat selection
eligibility for at least 4 seconds.
A remote controller will not display “
”
(Changeover Under Control) if a Cool/Heat
selection eligibility is granted to the remote
controller.
•
The icon “
” on each remote controller of
indoor units connected to the same outdoor unit or
BS unit will start blinking.
Vent mode setting changes are possible
regardless of the Cool/Heat selection eligibility.
If a Cool/Heat selection eligibility is set in the
“Cool/Heat selector” ( ), all the remote
controllers will display the icon “
” .
In this case, no Cool/Heat selection eligibility
can be set in the remote controllers.
Refer to the operation manual attached to the
outdoor unit for the details of the “Cool/Heat
selector”.
• Set a Cool/Heat selection eligibility as follows.
Selection Settings
The icon “
” (Changeover Under Control) will blink on all remote
controllers when the power is turned on for the first time.
2
•
Press the Mode Selector button (
) on the
remote controller for which the selection eligibility
to be set.
Then the Cool/Heat selection eligibility will be set
and the icon “
” will disappear.
The icon “
” will appear on the other
remote controllers.
01_EN_4P543053-1C.indd 25
10-May-19 4:13:29 PM
