10 Starting up the system
Installation and operation manual
10
BK+S
Madoka wired remote controller
4P596264-1 – 2019.11
From the left
P1P2
From the bottom
P1P2
9.3
Closing the controller
CAUTION
Never touch the internal parts of the controller.
CAUTION
When closing the controller, be careful not to pinch the
wiring.
NOTICE
To prevent damage, make sure the front of the controller is
clicked into the rear casing securely.
9.3.1
To close the controller
1
Click the front of the controller into the rear casing.
1
2
10
Starting up the system
The controller gets its power from the indoor unit. It will start up as
soon as it is connected. For the controller to be operable, therefore
make sure the indoor unit is powered on.
Once the controller is powered, it will automatically start up. If it is
the first and only controller that is connected to the indoor unit, it will
automatically get designated as a "Normal" master controller.
INFORMATION
For more information on how to designate the controller to
be of a different type (i.e. operable in "Normal", "Alarm
only", or "Supervisor" mode, as master controller or as
slave controller), see the installer and user reference
guide.
11
Maintenance
11.1
Maintenance safety precautions
WARNING
Before carrying out any maintenance or repair activities,
stop system operation with the controller, and turn off the
power supply circuit breaker.
Possible consequence:
electric shock or injury.
NOTICE
To clean the controller, do NOT use organic solvents, such
as paint thinner.
Possible consequence:
damage, electric
shock, or fire.
WARNING
Do
not
wash
the
remote
controller.
Possible
consequence:
electric leakage, electric shock, or fire.
INFORMATION
When the dirt on the surface cannot be removed easily
while cleaning the controller, soak the cloth in neutral
detergent diluted with water, squeeze the cloth tightly, and
clean the surface. Afterwards, wipe dry with a dry cloth.
11.2
To clean the controller
1
Wipe the screen and other surface parts of the controller with a
dry cloth.
11.3
Time to clean filter indication
When the indoor unit filter is dirty and needs to be cleaned, the
controller will indicate this by displaying
in the top left corner of
the home screen, and confronting you with the 'Time to clean filter'
screen as soon as you try to enter the main menu from the home
screen.
11.3.1
To remove the Time to clean filter
indication
Prerequisite:
On trying to enter the main menu from the home
screen, you are confronted with the 'Time to clean filter' screen.
1
Clean the filter.
2
Press
to remove the 'Time to clean filter' indication.
Summary of Contents for BRC1H52K
Page 11: ......