Si50-203
Overhaul Instructions
Semi-Hermetic Single Screw Compressor Version III
21
���
Removing the bearing
From the opposite side of the end with the C-type retainer ring, remove the outer ring of
the bearing by placing a bronze rod and hammering it. Since the outer ring is not
pressed in deeply, it can be removed easily.
Fig. 4-22 Removing main bearing holder bearing
2. Gate Rotor Bearings (Angular-Contact Bearing, Deep Groove Ball Bearing)
Remove the angular-contact ball bearing and deep groove ball bearing from the lower
bearing holder by using a bronze rod and hammer.
Fig. 4-23 Removing lower bearing holder bearing
Summary of Contents for (A)5LLF
Page 48: ...Si50 203 ii Index ...
